This topic has been archived. It cannot be replied.
-
枫下家园 / 美丽家居 / 请问懂木工大侠,想把hinge位置挪一下,要重新在柜子上打个圆的洞,但还不能穿透面板,得用什么工具呢?汗。。。
-not(not);
2009-9-15
(#5548788@0)
-
why hinge位置挪一下?
-oasis(oasis);
2009-9-15
(#5548827@0)
-
把柜子改短。
-not(not);
2009-9-15
(#5549029@0)
-
这个可以,1,把钻头量好位置,用胶布包上,2,用一个细钻头,量好位置,多余的部分放进drill里面,3,买一种stop,就是套在钻头外面,固定
-oasis(oasis);
2009-9-15
(#5549955@0)
-
router
-3854688(小鹏);
2009-9-15
(#5548842@0)
-
谢谢,太贵了,我就想打两个洞,不知道还有什么好办法。哎
-not(not);
2009-9-15
(#5549025@0)
-
你可以去租个router。
-xbox360(big麻);
2009-9-15
(#5549058@0)
-
一般的DRILL就可以,找一个木头块,根据需要(深度)调好,在上面转过去,就可以了一般的板子是5/8,留1/2的转头应该可以了。
------文字的表达越来越差了,实践一下就好了!!
-asdwl(asdwl);
2009-9-15
{88}
(#5549891@0)
-
这个方法也很好
-oasis(oasis);
2009-9-15
(#5549958@0)
-
什么圆洞?多大直径?小的圆洞,用stopper就可以控制深度,大的,比如那种在门板上的,把hinge放在里面的,用fostner bit + drill press,你保证不了垂直度的。
-livefish(活鱼);
2009-9-15
{129}
(#5550045@0)
-
thanks all of you guys' reply. I finally bought a smaller new cabinet. haha. thanks.
-not(not);
2009-9-16
(#5551089@0)